Hello everyone I finally managed to get everything in order and launched my crowd funding campaign. So if your interested in a Reflow Master Shield, go check it out. Click on the campaign card below to be redirected to the…
Blog Archives
Some stuff has arrived (“,)
Hello everyone So as I’ve mentioned, I’m currently focusing on getting the shield version of the reflow oven controller going before I’m off to Canada. I’ve collected the PCBs I had made on Friday and I’ve received the displays today.…
Tagged with: Arduino, Arduino Mega, Arduino Project, Electronics, PCB Art, PCB Graphics, Prototyping, reflow ovens, Solder reflow oven, Solder Reflow Oven Controller, Solder reflow oven shield, technology, UNO R3
Posted in Uncategorized
Posted in Uncategorized
Getting closer to the finish line
Hello Everyone Time just goes by way to fast, or maybe I just don’t have enough 😉 The past month I’ve been busy with redesigning the PCB to fit into an enclosure. I then designed one to fit the bill.…
Tagged with: Arduino, Arduino Mega, Arduino Mega2560, Arduino Project, Arduino Uno, Custom PCB, DIY Electronic Enclosure, EagleUp, Electronic Enclosure, Electronics, Prototyping, reflow ovens, Sketchup, Snap Together Enclosure, Solder reflow oven, Solder Reflow Oven Controller, Solder reflow oven shield, technology, UNO R3
Posted in Uncategorized
Posted in Uncategorized
Finalized Firmware – YEAH (“,)
Hello Everyone It’s been a month again, wow. In any case, in the past month I was able to complete my firmware and it seems to be working correctly. Below is a video demoing the firmware for you on Youtube.…
Temperature Calibration Resolved
Hello Everyone Its been a while again since my last post, but I’ve been a bit busy and preoccupied with various other things as well. Luckily I have some good news at least regarding the temperature measurement of the unit. I…
Solder Reflow Oven Shield Hardware Solved!
So when I finished with my hardware post previously I didn’t get the unit to work properly. The relays were working correctly but the temperature measurement wasn’t working correctly. I got weird values from the thermocouple conditioner and whether I…
Solder Reflow Oven Controller with a graphic interface – Part 1
So I’ve been looking at developing a second version of my portable battery charger. In researching the topic I found that I would either need to make use of a hot air gun, a hot plate or a solder reflow…
Tagged with: Arduino, Arduino Project, Electronics, GLCD, Graphic LCD, reflow ovens, Solder reflow oven, Solder Reflow Oven Controller, Solder reflow oven shield, technology, UNO R3
Posted in Uncategorized
Posted in Uncategorized
Paladin Enabling Technologies 